Netgear WC7600v2 – ProSAFE Wireless Controller 사용자 설명서

Configure the VRRP ID and local IP address of all primary controllers (that is, the master 
and the slaves) as described in the following table.

These settings are required so that the primary controllers and redundant controller can 
establish a redundancy group.

The following table also includes descriptions of the nonconfigurable fields.

Controller Role

This is a nonconfigurable field that shows that the role of the primary controller. 
The role is either master (for the master in the stack) or slave (for the slaves in 
the stack).

Controller IP

This is a nonconfigurable field that shows the IP address of the primary 
controller. This IP address is the address that you use to log in to the primary 
controller’s (master’s or slave’s) web management interface and was 
established when you configured the stack (see 

The controller IP address of the master in the stack is also the master IP 

address for the redundancy configuration.

VRRP ID [1-255]

For each primary controller, enter a number from 1 through 255 as the VRRP 
ID. For each primary controller, this number must be unique and not assigned 
to any other device in the network.

Local IP

For each primary controller, enter a local IP address. If a failover occurs, this IP 
address remains assigned to the primary controller and does not transfer to the 
redundant controller to let you identify the primary controller before and after 
the failover. For each primary controller, you must enter an IP address that is 
not assigned to any other device.