Netgear WC7600v1 - ProSAFE Wireless Controller 사용자 설명서

In the Syslog Settings section of the page, configure the settings as described in the 
following table.

Click the Apply button.

Your settings are saved.

Enable Syslog

Enable the syslog settings using the Enable Syslog check box to forward 
system wide logs to an external syslog server or to save to a storage device 
such as a USB or SD card connected to the wireless controller. By default, the 
syslog settings are disabled.

Log Level

From the Log Level menu, select one of the following levels:

LOG_LEVEL_CRIT. Critical errors only are logged.

LOG_LEVEL_ERR. Noncritical errors and critical errors are logged.

LOG_LEVEL_WARN. Warnings, noncritical errors, and critical errors are 
logged.

LOG_LEVEL_NOTICE. Notifications, warnings, noncritical errors, and 
critical errors are logged.

LOG_LEVEL_INFO. Informational messages, notifications, warnings, 
noncritical errors, and critical errors are logged.

Syslog Location

Select the External radio button if your network includes a syslog server.

Syslog Server IP Address Enter the IP address to which the wireless controller and managed access 

points send all syslogs, if the Enable Syslog check box is selected.

Before you configure the IP address of the syslog server on the wireless 

controller, make sure that you set up a syslog server (such as a computer running 
a syslog service) and that the syslog server is available on the network.

Server Port Number

Enter the number of the port at which your syslog server is configured to listen to 
requests.