Netgear WC7500 - ProSAFE® Wireless Controller 사용자 설명서

Group

The group to which the access point is assigned. 

After the access point discovery process, the access point is automatically 

assigned to the basic group. If you set up profile groups, you can assign the 
access point to another profile group by selecting one from the menu. You can 
also change the group assignment later on the WLAN Group Assignment page. 
For more information, see 

These fields show the IP address and other IP settings of the access point. By default, these fields are 
populated during the access point discovery process. The following are the functions of the radio buttons:

enable. By default, the enable radio button is selected, allowing the access point to function as a 
DHCP client. 

The IP Settings fields are masked out, preventing you from changing the IP settings.

disable. Select the disable radio button to disable the access point’s DHCP client. 

The IP Settings fields become available, allowing you to change the IP settings, including changes to 
the access point’s IP address.

IP Address

The IP address of the access point. 

Subnet Mask

The subnet mask of the access point. 

Default Gateway

The default gateway of the access point. 

Primary DNS Server

The primary DNS server of the access point. 

Secondary DNS Server The secondary DNS server of the access point. 

Managed VLAN

Enter a VLAN ID or leave the default ID. 

By default, the management VLAN is 1. For more information about management 
VLANs, see 

Untagged VLAN

Enter a VLAN ID or leave the default ID. 

By default, the untagged VLAN is 1 and the Untagged VLAN check box is 
selected. When the wireless controller sends frames associated with the untagged 
VLAN to the LAN (Ethernet) interface, those frames are untagged. When the 
wireless controller receives untagged traffic from the LAN (Ethernet) interface, 
those frames are assigned to the untagged VLAN.

Link Aggregation

You can enable link aggregation for Ethernet ports on the access point by 
selecting the enable radio button. By default, the disable radio button is selected 
and link aggregation is disabled.

Link aggregation for access point Ethernet ports is supported only for a 

WAC740 access point.