Netgear WNDAP350 – ProSAFE Dual Band Wireless-N Access Point 사용자 설명서

You can turn the WNDAP350 into a DHCP Server for wireless clients for both DHCP-enabled 
wireless clients. The default advanced IP wireless settings usually work well. This feature is 
intended for use by a systems administrator. By default, this feature is not enabled.



From the main menu under Configuration, select IP, and then select DHCP Server 
Settings. The DHCP Server Settings screen displays (see 

).

DHCP Server is disabled by default. Select the Enable radio button to enable this wireless 
access point as a DHCP server.

.

Configure the following TCP/IP configurations for using the WNDAP350 as a DHCP Server 
for wireless clients. 

DHCP Server. By default, the Dynamic Host Configuration Protocol (DHCP) server 
on the AP is disabled. If you enable it, all the wireless clients associated with the AP 
will get their IP addresses, subnet mask and default gateway settings automatically 
from the AP.

DHCP Server VLAN ID. All the stations that are part of the configured VLAN ID will 
get their IP addresses only from the AP.

Starting IP Address. Enter the starting IP address that can be assigned from the 
DHCP server on this Access Point. 

Ending IP Address. Enter the Ending IP address that can be assigned from the 
DHCP server on this Access Point 

Subnet Mask. The Access Point will assign the specified subnet mask to the 
connected wireless stations.