Netgear WNDAP350 – ProSAFE Dual Band Wireless-N Access Point 사용자 설명서

Configure and verify the following parameters for both access points:

Verify that the LAN network configuration of the WNDAP350 wireless access points 
both are configured to operate in the same LAN network address range as the LAN 
devices

Both use the same ESSID, Channel, authentication mode, if any, and security 
settings if security is in use.

Verify connectivity across the LAN 1 and LAN 2. 

A computer on either LAN segment should be able to connect to the Internet or share 

files and printers of any other PCs or servers connected to LAN Segment 1 or LAN 
Segment 2.

Click Apply to save your settings.

 shows a point-to-multi-point bridge 

configuration.



Under the Configuration tab, select Wireless Bridge. Then, select Bridging. The 
Bridging screen displays.

Configure the Operating Mode of the WNDAP350 wireless access points.

WNDAP350 (AP1) on LAN Segment 1 in Point-to-Point Bridge mode with the Remote 
MAC Address of AP2.

Because it is in the central location, configure WNDAP350 (AP2) on LAN Segment 2 
in Point-to-Multi-Point Bridge mode. The MAC addresses of the adjacent APs are 
required in AP2.

'Master' AP in 
Point-to-Multi-Point 
Bridge Mode

AP in 
Point-to-Point 
Bridge Mode

AP in 
Point-to-Point 
Bridge Mode

E T H E R N E T

R E S E T

5 - 1 2 V   D C

E T H E R N E T

R E S E T

5 - 1 2 V   D C

E T H E R N E T

R E S E T

5 - 1 2 V   D C