Netgear WN604 - Wireless-N 150 Access Point 사용자 설명서

Configure a Point-to-Multi-Point Wireless Bridge



Select Configuration > Wireless Bridge > Bridging. The Bridging screen displays.

Configure the operating mode of the access points.

Configure the first access point (AP 1) on LAN segment 1 in point-to-point bridge 

mode with the remote MAC address of AP 2.

Because it is in the central location, configure AP 2 on LAN segment 2 in 

point-to-multi-point bridge mode. The MAC addresses of the adjacent APs are 
required in AP 2.

Configure AP 3 on LAN 3 in point-to-point bridge mode with the remote MAC address 
of AP 2.

Verify the following parameters for all access points:

Verify that the LAN networks of the access points are configured to operate in the 

same LAN network address range as the LAN devices.

Only one access point is configured in point-to-multi-point bridge mode, and all the 

others are in point-to-point bridge mode.

All access points have to be on the same LAN. That is, all the APs LAN IP address 

must be in the same network.

If you use DHCP, for all WN604 Wireless Access Points, in the IP Settings section, the 

DHCP Client should be enabled so that APs obtain IP addresses automatically.

All access points use the same SSID, channel, authentication mode, if any, and 

encryption in use.