Netgear Business Central Wireless Manager (BCWM) 빠른 설정 가이드

Follow the procedure in this appendix only if your access point does not yet run the minimum standalone version
that is required to upgrade the access point to the cloud-enabled firmware version (see the table in 

 on page 6).

Using the web management interface of the access point, upgrade the access point to the minimum required
standalone firmware. When you are done, continue with the procedure that is described in 

 on page 7.

Visit 

.

Navigate to the support page for your access point and download the minimum required standalone firmware
version for your access point.

For more information, see the table in 

on page 6.

Read the release notes before upgrading the firmware.

If the access point does not receive power through Power over Ethernet (PoE), apply power to the access
point and wait for the access point to complete its startup procedure.

Open a browser on your computer.

In the address bar, enter the IP address of the access point.

By default, the access point functions as a DHCP client. If the access point is installed in a network that
includes a DHCP server, the IP address of the access point is issued by the DHCP server.

If the access point is not connected to a DHCP server or is accessible only over its default IP address, do
the following:

Change the IP address of your computer to an IP address in the 192.168.0.x subnet, which is the subnet
in which the access point’s default IP address is located.

For example, change the computer’s IP address to 192.168.0.210.

Connect your computer to the access point with an Ethernet cable.

In the address bar of the browser, enter the default IP address of the access point:

WAC730. 192.168.0.100

WAC720. 192.168.0.100

WNDAP660. 192.168.0.100

WNDAP360. 192.168.0.100

WNDAP350. 192.168.0.237