Netgear WNAP320 - ProSAFE Wireless-N Access Point 참조 매뉴얼

Enter the CLI commands that you want to use. You can enter show configuration to 
display the available CLI commands. The CLI commands are also listed in 

.

Upgrade the Wireless Access Point Software 

The software of the wireless access point is stored in flash memory and can be upgraded as 
NETGEAR releases new software. You can download upgrade files from the NETGEAR 
website. If the upgrade file is compressed (.zip file), you must first extract the image (.rmt) file 
before sending it to the wireless access point. You can send the upgrade file using your 
browser. There are two methods to perform a software upgrade that are described in the 
following sections:

The Web browser that you use to upload new firmware into the 

wireless access point must support HTTP uploads. Use a browser 
such as Microsoft Internet Explorer 6.0 or later or Mozilla 1.5 or later.

You cannot perform the software upgrade from a computer that is 

connected to the wireless access point over a wireless link. You 
must use a computer that is connected to the wireless access point 
over an Ethernet cable.

When uploading software to the wireless access point, do not 
interrupt the Web browser by closing the window, clicking a link, 
or loading a new page. If the browser is interrupted, the upload 
might fail, corrupt the software, and render the wireless access 
point completely inoperable.