Netgear FVM318 – Cable and DSL ProSafe Wireless VPN Security Firewall 참조 매뉴얼
Reference Manual for the Model FVM318 Cable/DSL ProSafe Wireless VPN Security Firewall
3-16
Wireless Configuration
b.
In most cases, you can leave the IPSec Gateway as “LAN Gateway”, which indicates the
firewall. If you are not using the firewall as your network’s default gateway, change IPSec
Gateway to indicate either the IP Address or the network name of the firewall.
firewall. If you are not using the firewall as your network’s default gateway, change IPSec
Gateway to indicate either the IP Address or the network name of the firewall.
c.
Enter the User Name and the Pre-Shared Key value that you programmed for this PC in
the firewall’s IPSec Client Settings menu.
the firewall’s IPSec Client Settings menu.
d.
Click OK.
e.
In the taskbar tray, right-click on the SafeNet icon and select Activate Security Policy in
the task menu. The SafeNet icon will now appear without the red bar, as shown below.
the task menu. The SafeNet icon will now appear without the red bar, as shown below.
Figure 3-18.
SafeNet system tray icon showing enabled condition
4. Test the SoftRemote Basic VPN Connection.
To check the VPN Connection, you can initiate a request from the PC to the firewall. The
simplest method is to ping from the PC to the firewall, as shown below:
simplest method is to ping from the PC to the firewall, as shown below:
a.
On the Windows taskbar, click the Start button, and then click Run.
b.
Type
ping -t 192.168.0.1
, and then click OK.
Figure 3-19.
Run Ping from Windows Start Menu