Netgear UTM50 – ProSECURE Unified Threat Management (UTM) Appliance 사용자 설명서
Configure VPN Tunnels
35
NETGEAR ProSAFE VPN Client
3.
Click the Advanced tab.
4.
Complete the Redun. GW field.
5.
Enter the IP address of the gateway.
6.
Select Configuration > Save or press Ctrl + S.
Your settings are saved.
Configure Mode Config Settings
Mode Config allows the VPN Client to receive VPN configuration information from the remote
VPN gateway. The remote VPN gateway must support the Mode Config feature. When Mode
Config is enabled, the following information is negotiated between the VPN client and the
remote VPN gateway during the authentication phase:
VPN gateway. The remote VPN gateway must support the Mode Config feature. When Mode
Config is enabled, the following information is negotiated between the VPN client and the
remote VPN gateway during the authentication phase:
•
Virtual IP address of the VPN client
•
DNS server address (optional)
•
WINS server address (optional)
The virtual IP address that is issued by the remote VPN gateway is displayed in the VPN
Client Address field on the IPSec pane with the IPSec tab selected.
Client Address field on the IPSec pane with the IPSec tab selected.
If the Mode Config feature is not available or not supported on the remote VPN gateway,
manually specify the DNS and WINS server addresses on the VPN client. For more
information,
manually specify the DNS and WINS server addresses on the VPN client. For more
information,
To set up Mode Config:
1.
On the client computer desktop, double-click the VPN Client shortcut
.
The VPN Configuration page displays.
2.
In the VPN Tunnel Tree pane, right-click the name of the IKE configuration.
The Authentication page displays.