Netgear M5300-52G-POE+ (GSM7252PSv1h2) - ProSAFE 48+4 L2+ POE Stackable Managed Switch 소프트웨어 가이드
Routing Commands
796
M5300, M6100, and M7100 Series ProSAFE Managed Switches
Routing Information Protocol Commands
This section describes the commands you use to view and configure Routing Information
Protocol (RIP), which is a distance-vector routing protocol that you use to route traffic within a
small network.
Protocol (RIP), which is a distance-vector routing protocol that you use to route traffic within a
small network.
Only the following switches support RIP:
•
M6100
•
M5300-28G3
•
M5300-52G3
•
M5300-28GF3
The following switches support RIP with an L3 license:
•
M5300-28G
•
M5300-52G
•
M5300-28G-POE+
•
M5300-52G-POE+
router rip
Use this command to enter Router RIP mode.
enable (RIP)
This command resets the default administrative mode of RIP in the router (active).
no enable (RIP)
This command sets the administrative mode of RIP in the router to inactive.
Format
router rip
Mode
Global Config
Default
enabled
Format
enable
Mode
Router RIP Config
Format
no enable
Mode
Router RIP Config