Netgear XCM8806 - 8800 SERIES 6-SLOT CHASSIS SWITCH 하드웨어 매뉴얼
Chapter 14. QoS Commands
|
520
14
14.
QoS Commands
This chapter describes commands for:
•
Configuring Quality of Service (QoS) profiles
•
Creating traffic groupings and assigning the groups to QoS profiles
•
Configuring, enabling, and disabling explicit class-of-service traffic groupings (802.1p
and DiffServ)
•
Configuring traffic grouping priorities
•
Metering using ACLs
•
Verifying configuration and performance
•
Egress traffic rate limiting
For an introduction to QoS features, see the NETGEAR 8800 User Manual.
configure diffserv examination code-point qosprofile
The syntax is:
configure diffserv examination code-point <code_point> {qosprofile} <qosprofile>
Description
Configures the default ingress DiffServ code point (DSCP) to QoS profile mapping.
Syntax Description
Default
See
code-point
Specifies a DiffServ code point (a 6-bit value in the IP-TOS byte in the IP
header). Supported values are 0 to 63.
header). Supported values are 0 to 63.
qosprofile
Specifies the QoS profile to which the DiffServ code point is mapped.