Netgear M4300-52G (GSM4352S) - Stackable Managed Switch with 48x1G and 4x10G including 2x10GBASE-T and 2xSFP+ Layer 3 사용자 설명서
OSPF and OSPFv3
339
M4200 and M4300 Series ProSAFE Managed Switches Web Management User Manual
Configure OSPF
Note:
OSPF is supported on the M4300 series switches only.
Configure Basic OSPF Settings
To configure basic OSPF settings:
1.
Launch a web browser.
2.
Enter http://<ipaddress> in the web browser address field.
The login window opens.
3.
Enter the user name and password.
The default admin user name is admin and the default admin password is blank, that is,
do not enter a password.
do not enter a password.
4.
Click the Login button.
The System Information page displays.
5.
Select Routing > OSPF > Basic > OSPF Configuration.
6.
Select the Admin Mode Disable or Enable radio button.
If you select Enable, OSPF is activated for the switch. By default, OSPF is enabled. You
must configure a router ID before OSPF can become operational. Use the IP
Configuration page to configure a router ID or issue the config router id CLI
command. For more information, see
must configure a router ID before OSPF can become operational. Use the IP
Configuration page to configure a router ID or issue the config router id CLI
command. For more information, see
The Router ID displays the 32-bit integer in dotted-decimal format that uniquely identifies
the router within the autonomous system (AS).
the router within the autonomous system (AS).
To change the router ID, you must first disable OSPF. After you set the new router ID, you
must reenable OSPF for the change to take effect. The default value is 0.0.0.0, although
this is not a valid router ID.
must reenable OSPF for the change to take effect. The default value is 0.0.0.0, although
this is not a valid router ID.
7.
Click the Apply button.
The updated configuration is sent to the switch. Configuration changes take effect
immediately.
immediately.