Netgear M4300-52G (GSM4352S) - Stackable Managed Switch with 48x1G and 4x10G including 2x10GBASE-T and 2xSFP+ Layer 3 소프트웨어 가이드
Using the Command-Line Interface
12
M4200 and M4300 Series ProSAFE Managed Switches
Common Parameter Values
Parameter values might be names (strings) or numbers. To use spaces as part of a name
parameter, enclose the name value in double quotes. For example, the expression “System
Name with Spaces” forces the system to accept the spaces. Empty strings (““) are not valid
user-defined strings. The following table describes common parameter values and value
formatting.
parameter, enclose the name value in double quotes. For example, the expression “System
Name with Spaces” forces the system to accept the spaces. Empty strings (““) are not valid
user-defined strings. The following table describes common parameter values and value
formatting.
| Vertical bars
choice1 | choice2
Separates the mutually exclusive choices.
[{ }] Braces within
square brackets
[{choice1 | choice2}]
Indicates a choice within an optional element. This
format is used mainly for complicated commands
format is used mainly for complicated commands
Table 2. Parameter Descriptions
Parameter
Description
ipaddr
This parameter is a valid IPv4 address. You can enter the IP address in the
following formats:
following formats:
•
a
(32 bits)
•
a.b
(8.24 bits)
•
a.b.c
(8.8.16 bits)
•
a.b.c.d
(8.8.8.8)
In addition to these formats, the CLI accepts decimal, hexadecimal and octal
formats through the following input formats (where n is any valid hexadecimal, octal
or decimal number):
formats through the following input formats (where n is any valid hexadecimal, octal
or decimal number):
•
0xn
(CLI assumes hexadecimal format.)
•
0n
(CLI assumes octal format with leading zeros.)
•
n
(CLI assumes decimal format.)
ipv6-addr
This parameter is a valid IPv6 address. You can enter the IP address in the
following formats:
following formats:
•
FE80:0000:0000:0000:020F:24FF:FEBF:DBCB
•
FE80:0:0:0:20F:24FF:FEBF:DBCB
•
FE80::20F24FF:FEBF:DBCB
•
FE80:0:0:0:20F:24FF:128:141:49:32
For additional information, refer to RFC 3513.
Interface or
unit/slot/port
unit/slot/port
Valid slot and port number separated by a forward slash. For example, 0/1
represents slot number 0 and port number 1.
represents slot number 0 and port number 1.
Logical Interface
Represents a logical slot and port number. This is applicable in the case of a
port-channel (LAG). You can use the logical unit/slot/port to configure the
port-channel.
port-channel (LAG). You can use the logical unit/slot/port to configure the
port-channel.
Character strings
Use double quotation marks to identify character strings, for example, “System
Name with Spaces”. An empty string (“”) is not valid.
Name with Spaces”. An empty string (“”) is not valid.
Table 1. Parameter Conventions (continued)
Symbol
Example
Description