Netgear M4300-52G (GSM4352S) - Stackable Managed Switch with 48x1G and 4x10G including 2x10GBASE-T and 2xSFP+ Layer 3 소프트웨어 가이드
Management Commands
123
M4200 and M4300 Series ProSAFE Managed Switches
Command example:
(NETGEAR Switch) #
(NETGEAR Switch) #show domain-name
Domain : Enable
Domain-name :abc
SNMP Commands
This section describes the commands that you can use to configure Simple Network
Management Protocol (SNMP) on the switch. You can configure the switch to act as an
SNMP agent so that it can communicate with SNMP managers on your network.
Management Protocol (SNMP) on the switch. You can configure the switch to act as an
SNMP agent so that it can communicate with SNMP managers on your network.
snmp-server
This command sets the name and the physical location of the switch and the organization
responsible for the network. The range for the name, loc and con parameters is from 1 to 31
alphanumeric characters.
responsible for the network. The range for the name, loc and con parameters is from 1 to 31
alphanumeric characters.
snmp-server community
This command adds (and names) a new SNMP community. A community name is associated
with the switch and with a set of SNMP managers that manage the community with a
specified privileged level. The length of the name parameter can be up to 16 case-sensitive
characters.
with the switch and with a set of SNMP managers that manage the community with a
specified privileged level. The length of the name parameter can be up to 16 case-sensitive
characters.
Note:
Community names in the SNMP Community table must be unique. If
multiple entries are made using the same community name, the first
entry is kept and processed and all duplicate entries are ignored.
multiple entries are made using the same community name, the first
entry is kept and processed and all duplicate entries are ignored.
Default
none
Format
snmp-server {sysname name | location loc | contact con}
Mode
Global Config
Format
snmp-server community name
Mode
Global Config