Netgear M4300-52G (GSM4352S) - Stackable Managed Switch with 48x1G and 4x10G including 2x10GBASE-T and 2xSFP+ Layer 3 소프트웨어 가이드
Switching Commands
580
M4200 and M4300 Series ProSAFE Managed Switches
show port-security violation
This command displays the source MAC address of the last packet discarded on a locked
port. Instead of unit/slot/port, lag lag-intf-num can be used as an alternate way to
specify the LAG interface, in which lag-intf-num is the LAG port number.
port. Instead of unit/slot/port, lag lag-intf-num can be used as an alternate way to
specify the LAG interface, in which lag-intf-num is the LAG port number.
LLDP (802.1AB) Commands
This section describes the command you use to configure Link Layer Discovery Protocol
(LLDP), which is defined in the IEEE 802.1AB specification. LLDP allows stations on an 802
LAN to advertise major capabilities and physical descriptions. The advertisements allow a
network management system (NMS) to access and display this information.
(LLDP), which is defined in the IEEE 802.1AB specification. LLDP allows stations on an 802
LAN to advertise major capabilities and physical descriptions. The advertisements allow a
network management system (NMS) to access and display this information.
lldp transmit
Use this command to enable the LLDP advertise capability on an interface or a range of
interfaces.
interfaces.
no lldp transmit
Use this command to return the local data transmission capability to the default.
Format
show port-security violation
{unit/slot/port | lag lag-intf-num}
Mode
Privileged EXEC
Term
Definition
MAC Address
The source MAC address of the last frame that was discarded at a locked port.
VLAN ID
The VLAN ID, if applicable, associated with the MAC address of the last frame that was discarded at
a locked port.
a locked port.
Default
disabled
Format
lldp transmit
Mode
Interface Config
Format
no lldp transmit
Mode
Interface Config