Netgear GS752TXS - Stackable Smart Gigabit Ethernet Switch 관리자 가이드
220
GS752TXS and GS728TXS Smart Switches
Port Security Interface Configuration
A MAC address can be defined as allowable by one of two methods: dynamically or statically.
Both methods are used concurrently when a port is locked.
Both methods are used concurrently when a port is locked.
Dynamic locking implements a first arrival mechanism for port security. You specify how
many addresses can be learned on the locked port. If the limit has not been reached, then a
packet with an unknown source MAC address is learned and forwarded normally. When the
limit is reached, no more addresses are learned on the port. Any packets with source MAC
addresses that were not already learned are discarded. You can effectively disable dynamic
locking by setting the number of allowable dynamic entries to zero.
many addresses can be learned on the locked port. If the limit has not been reached, then a
packet with an unknown source MAC address is learned and forwarded normally. When the
limit is reached, no more addresses are learned on the port. Any packets with source MAC
addresses that were not already learned are discarded. You can effectively disable dynamic
locking by setting the number of allowable dynamic entries to zero.
Static locking allows you to specify a list of MAC addresses that are allowed on a port. The
behavior of packets is the same as for dynamic locking: only packets with an allowable
source MAC address can be forwarded.
behavior of packets is the same as for dynamic locking: only packets with an allowable
source MAC address can be forwarded.
To configure port security settings:
1.
Select Security
Traffic Control
> Port Security
Interface Configuration
.
2.
To configure port security settings for a Link Aggregation Group (LAG), click LAGS.
3.
To configure port security settings for both physical ports and LAGs, click ALL.
4.
To configure settings for a physical port, enter the port in unit/slot/port format and click on the
Go
Go
button.
The entry corresponding to the specified port will be selected.
5.
Select the check box next to the port or LAG to configure.
Select multiple check boxes to apply the same setting to all selected interfaces. Select
the check box in the heading row to apply the same settings to all interfaces.
the check box in the heading row to apply the same settings to all interfaces.