Netgear XCM8806 - 8800 SERIES 6-SLOT CHASSIS SWITCH 사용자 설명서

You can extend a network or subscriber VLAN to another switch without configuring a PVLAN 
on that switch. This configuration is introduced in 

on page 256. 

To add a network VLAN port as a PVLAN endpoint, use the following command:

configure {vlan} <vlan_name> add ports <port_list> tagged private-vlan 

end-point

To configure the port on the switch that is outside of the PVLAN, use the following command:

configure {vlan} <vlan_name> add ports <port_list> tagged

NETGEAR 8800 series switches require a loopback port for certain configurations. If two or 
more subscriber VLANs have overlapping ports (where the same ports are assigned to both 
VLANs), each of the subscriber VLANs with overlapping ports must have a dedicated 
loopback port.

The loopback port can be added when the subscriber VLAN is added to the PVLAN.

The default configuration for Layer 3 PVLAN communications is described in 

on page 259. To enable Layer 3 communications between all ports in a 

PVLAN, use the following command:

configure iparp add proxy [<ipNetmask> | <ip_addr> {<mask>}] {vr <vr_name>} 

{<mac> | vrrp} {always}

Specify the IP address or subnet specified for the network VLAN in the PVLAN. Use the 

always

 option to ensure that the switch will reply to ARP requests, regardless of the VLAN 

from which it originated.

To delete an existing PVLAN, use the following command:

delete private-vlan <name>

When you remove a VLAN from a PVLAN, you remove the association between a VLAN and 
the PVLAN. Both the VLAN and PVLAN exist after the removal.

To remove a network or subscriber VLAN from a PVLAN, use the following command:

configure private-vlan <name> delete [network | subscriber] <vlan_name>

Displaying PVLAN Information

The following sections describe how to display PVLAN information: