Netgear XCM8806 - 8800 SERIES 6-SLOT CHASSIS SWITCH 사용자 설명서

Configuring STP on the Switch

To configure basic STP:

Create one or more STPDs using the following command:

create stpd <stpd_name>

Add one or more VLANs to the STPD using the following command:

configure stpd <stpd_name> add vlan <vlan_name> ports [all | <port_list>] {[dot1d | 
emistp | pvst-plus]}

Define the carrier VLAN using the following command:

configure stpd <stpd_name> tag <stpd_tag>

 

Enable STP for one or more STPDs using the following command:

enable stpd {<stpd_name>}

After you have created the STPD, you can optionally configure STP parameters for the 
STPD.

You should not configure any STP parameters unless you have 

considerable knowledge and experience with STP. The default STP 
parameters are adequate for most networks.

The following parameters can be configured on each STPD:

Hello time (In an MSTP environment, configure this only on the CIST.)

Forward delay

Max age (In an MSTP environment, configure this only on the CIST.)

Max hop count (MSTP only)

Bridge priority

StpdID (STP, RSTP, EMISTP, and PVST+ only)

MSTI ID (MSTP only)

The following parameters can be configured on each port:

Path cost

Port priority

Port mode