Netgear M5300-52G (GSM7252S) - ProSAFE 48-port Gigabit L2+ Managed Stackable Switch 소프트웨어 가이드
IP Multicast Commands
1137
M5300, M6100, and M7100 Series ProSAFE Managed Switches
Command example:
(NETGEAR) # show ip pim rp mapping candidate
RP Address.................................... 192.168.10.1
Group Address.............................. 224.1.2.1
Group Mask................................. 255.255.0.0
Origin..................................... BSR
C-RP Advertisement Interval (secs)......... 60
Next Candidate RP Advertisement (hh:mm:ss). 00:00:15
Command example:
If no RP Group mapping exist on the router, the following message is displayed:
No RP-Group mappings exist on this router.
Internet Group Message Protocol Commands
This section describes the commands you use to view and configure Internet Group
Message Protocol (IGMP) settings.
Message Protocol (IGMP) settings.
ip igmp
This command sets the administrative mode of IGMP in the system to active on an interface,
range of interfaces, or on all interfaces.
range of interfaces, or on all interfaces.
no ip igmp
This command sets the administrative mode of IGMP in the system to inactive.
Default
disabled
Format
ip igmp
Modes
Global Config
Interface Config
Format
no ip igmp
Modes
Global Config
Interface Config