Netgear M5300-52G (GSM7252S) - ProSAFE 48-port Gigabit L2+ Managed Stackable Switch 소프트웨어 가이드

This section describes the commands you use to view and configure VLAN routing and to 
view VLAN routing status information.

This command enables routing on a VLAN. The vlanid value has a range from 1 to 4093. 
The interface-id

value has a range from 1 to 128. Typically, you do not supply the 

interface ID argument, and the system automatically selects the interface ID. However, if you 
specify an interface ID, the interface ID becomes the port number in the unit/slot/port 
for the VLAN routing interface. 

If you select an interface ID that is already in use, the CLI displays an error message and 
does not create the VLAN interface. For products that use text-based configuration, including 
the interface ID in the vlan routing command for the text configuration ensures that the 
unit/slot/port

 for the VLAN interface stays the same across a restart. Keeping the 

 the same ensures that the correct interface configuration is applied to 

each interface when the system restarts.

This command deletes routing on a VLAN. 

The following example specifies a VLAN ID value. The interface ID argument is not used.

(NETGEAR Switch)(Vlan)#vlan 14

(NETGEAR Switch)(Vlan)#vlan routing 14 ?

<cr>                     Press enter to execute the command.

<1-24>                  Enter interface ID

Typically, you press Enter without supplying the Interface ID value; the system automatically 
selects the interface ID.

The following example specifies interface ID 51 for VLAN 14 interface. The interface ID 
becomes the port number in the unit/slot/port for the VLAN routing interface. In this 
example, unit/slot/port is 4/51 for VLAN 14 interface. 

Format

vlan routing vlanid [interface-id] 

Mode

VLAN Config

Format

no vlan routing vlanid 

Mode

VLAN Config