Netgear M5300-52G (GSM7252S) - ProSAFE 48-port Gigabit L2+ Managed Stackable Switch 소프트웨어 가이드
Monitor the System
687
M6100, M5300, and M7100 Series Managed Switches
Perform a Cable Test
To perform a cable test:
1.
Prepare your computer with a static IP address in the 169.254.100.0 subnet, for
example, 169.254.100.201.
2.
Connect an Ethernet cable from an Ethernet port on your computer to an Ethernet port on
the switch.
3.
Launch a web browser.
4.
Enter the IP address of the switch in the web browser address field.
The default IP address of the switch is 169.254.100.100.
The Login screen displays.
5.
Enter the user name and password.
The default admin user name is admin and the default admin password is blank, that is,
do not enter a password.
do not enter a password.
6.
Click the Login button.
The web management interface menu displays.
7.
Select Monitoring > Ports > Cable Test.
8.
Port
. Indicates the interface to which the cable to be tested is connected.
9.
Click the Apply button.
A cable test is performed on the selected interface. The cable test might take up to two
seconds to complete. If the port has an active link, the cable status is always Normal. The
command returns a cable length estimate if this feature is supported by the PHY for the
current link speed. Note that if the link is down and a cable is attached to a 10/100
Ethernet adapter then the cable status might be Open or Short because some Ethernet
adapters leave unused wire pairs unterminated or grounded.
command returns a cable length estimate if this feature is supported by the PHY for the
current link speed. Note that if the link is down and a cable is attached to a 10/100
Ethernet adapter then the cable status might be Open or Short because some Ethernet
adapters leave unused wire pairs unterminated or grounded.