Netgear FVS336Gv2 – ProSafe Dual WAN Gigabit Firewall with SSL & IPSec VPN 참조 매뉴얼
Protect Your Network
326
ProSAFE Dual WAN Gigabit WAN SSL VPN Firewall FVS336Gv2
3.
The remote system receives the computer’s request and responds using the incoming port
or ports that are associated with the port triggering rule on the VPN firewall.
or ports that are associated with the port triggering rule on the VPN firewall.
4.
The VPN firewall matches the response to the previous request and forwards the response
to the computer.
to the computer.
Without port triggering, the response from the external application would be treated as a new
connection request rather than a response to a request from the LAN network. As such, it
would be handled in accordance with the inbound port forwarding rules, and most likely
would be blocked.
connection request rather than a response to a request from the LAN network. As such, it
would be handled in accordance with the inbound port forwarding rules, and most likely
would be blocked.
Note these restrictions about port triggering:
•
Only one computer can use a port triggering application at any time.
•
After a computer has finished using a port triggering application, there is a short time-out
period before the application can be used by another computer. This time-out period is
required so that the VPN firewall can determine that the application has terminated.
required so that the VPN firewall can determine that the application has terminated.
Note:
For additional ways of allowing inbound traffic, see
Add a Port Triggering Rule
The following procedure describes how to add a port triggering rule.
To add a port triggering rule:
1.
On your computer, launch an Internet browser.
2.
In the address field of your browser, enter the IP address that was assigned to the VPN
firewall during the installation process.
firewall during the installation process.
The VPN firewall factory default IP address is 192.168.1.1.
The NETGEAR Configuration Manager Login screen displays.
3.
In the Username field, type your user name and in the Password / Passcode field, type
your password.
your password.
For the default administrative account, the default user name is admin and the default
password is password.
password is password.
4.
If you changed the default domain or were assigned a domain, from the Domain menu,
select the domain.
select the domain.
If you did not change the domain or were not assigned a domain, leave the menu
selection at geardomain.
selection at geardomain.
5.
Click the Login button.
The Router Status screen displays.
6.
Select Security > Port Triggering.