Netgear FVS336Gv2 – ProSafe Dual WAN Gigabit Firewall with SSL & IPSec VPN 참조 매뉴얼

The following procedure describes how to configure Dead Peer Detection for an existing IKE 
policy.



On your computer, launch an Internet browser.

In the address field of your browser, enter the IP address that was assigned to the VPN 
firewall during the installation process.

The VPN firewall factory default IP address is 192.168.1.1.

The NETGEAR Configuration Manager Login screen displays.

In the Username field, type your user name and in the Password / Passcode field, type 
your password.

For the default administrative account, the default user name is admin and the default 
password is password.

If you changed the default domain or were assigned a domain, from the Domain menu, 
select the domain.

If you did not change the domain or were not assigned a domain, leave the menu 
selection at geardomain.

Click the Login button.

The Router Status screen displays.

If the IKE policy for which you want to configure Dead Peer Detection is associated with a 
VPN policy, first disable the VPN policy:

a. Select VPN > IPSec VPN > VPN Policies.

The VPN Policies screen displays the IPv4 settings.

b.  To disable a VPN policy for IPv6 instead of IPv4, in the upper right, select the IPv6 

radio button.

The VPN Policies screen displays the IPv6 settings.

c.  In the List of VPN policies table, select the VPN policy that is associated with the 

IKE policy that you want to change.

When you use the VPN IPsec Wizard, the VPN and IKE policies that 
are added automatically have the same name.

d.  Click the Disable button.

The VPN policy is disabled. The green circle to the left of the VPN policy turns gray.

Select VPN > IPSec VPN. 

The IPSec VPN submenu tabs display with the IKE Policies screen for IPv4 in view.