Netgear FVS318N – Prosafe Wireless N VPN Firewall 참조 매뉴얼
IPv4 and IPv6 Internet and Broadband Settings
50
ProSAFE Wireless-N 8-Port Gigabit VPN Firewall FVS318N
3.
Click Apply to save your settings.
To delete one or more tunnels:
1.
On the ISATAP Tunnels screen, select the check box to the left of each tunnel that you
want to delete, or click the Select All table button to select all tunnels.
want to delete, or click the Select All table button to select all tunnels.
2.
Click the Delete table button.
View the Tunnel Status and IPv6 Addresses
The IPv6 Tunnel Status screen displays the status of all active 6to4 and ISATAP tunnels and
their IPv6 addresses.
their IPv6 addresses.
To view the status of the tunnels and IPv6 addresses:
Select Monitoring > Router Status > Tunnel Status. The Tunnel Status screen displays:
Figure 28.
The IPv6 Tunnel Status table shows the following fields:
•
Tunnel Name. The tunnel name for the 6to4 tunnel is always sit0-WAN1 (SIT stands for
simple Internet transition); the tunnel name for an ISATAP tunnel is isatapx-LAN, in which
x is an integer.
simple Internet transition); the tunnel name for an ISATAP tunnel is isatapx-LAN, in which
x is an integer.
•
IPv6 Address. The IPv6 address of the local tunnel endpoint.
Configure Stateless IP/ICMP Translation
Stateless IP/ICMP Translation (SIIT) is a transition mechanism algorithm that translates
between IPv4 and IPv6 packet headers. Using SIIT, an IPv6 device that does not have a
permanently assigned IPv4 addresses can communicate with an IPv4-only device.
between IPv4 and IPv6 packet headers. Using SIIT, an IPv6 device that does not have a
permanently assigned IPv4 addresses can communicate with an IPv4-only device.
SIIT functions with IPv4-translated addresses, which are addresses of the format
0::ffff:0:0:0/96 for IPv6-enabled devices. You can substitute an IPv4 address in the format
a.b.c.d for part of the IPv6 address so that the IPv4-translated address becomes
0::ffff:0:a.b.c.d/96.
0::ffff:0:0:0/96 for IPv6-enabled devices. You can substitute an IPv4 address in the format
a.b.c.d for part of the IPv6 address so that the IPv4-translated address becomes
0::ffff:0:a.b.c.d/96.
For SIIT to function, the routing mode needs to be IPv4 / IPv6. NETGEAR’s implementation of
SIIT lets you enter a single IPv4 address on the SIIT screen. This IPv4 address is then used
in the IPv4-translated address for IPv6 devices to enable communication between IPv4-only
devices on the wireless VPN firewall’s LAN and IPv6-only devices on the WAN.
SIIT lets you enter a single IPv4 address on the SIIT screen. This IPv4 address is then used
in the IPv4-translated address for IPv6 devices to enable communication between IPv4-only
devices on the wireless VPN firewall’s LAN and IPv6-only devices on the WAN.