Netgear FVS336Gv2 – ProSafe Dual WAN Gigabit Firewall with SSL & IPSec VPN 참조 매뉴얼

The following table describes the configuration commands that let you save or cancel 
configuration changes in the CLI. You can use these commands in any of the four main 
configuration modes. These commands are not preceded by a period.

Save the configuration changes.

Save the configuration changes and exit the current configuration mode.

Roll back the configuration changes.

After you issue a command that includes the word configure, add, or edit, you enter a 

configuration mode from which you can issue keywords and associated parameters. 

These are examples of commands for which you must save your changes:

 <vlan id> lets you enter the net-config [lan-ipv4] 

configuration mode. After you make your changes, issue save or exit to save your 
changes.

 lets you enter the 

security-config

 

[approved-urls] configuration mode. After you make your changes, issue 

 or exit to save your changes.

 lets you enter the vpn-config [user-groups] 

configuration mode. After you make your changes, issue save or exit to save your 
changes.

You do not need to save your changes after you issue a command that deletes, disables, or 
enables a row ID, name, IP address, or MAC address, or that lets you make a configuration 
change without entering another configuration mode.

These are examples of commands that you do not need to save:

net lan dhcp reserved_ip delete <mac address> 

 <vpn policy name>

security firewall ipv4 enable <row id> 

 {Allow | Block}