Netgear FVS318v3 – Cable/DSL ProSafe VPN Firewall with 8-Port Switch 참조 매뉴얼

7-8

Advanced Configuration

b. To allow access from a range of IP addresses on the Internet, select IP address range.

Enter a beginning and ending IP address to define the allowed range. 

c. To allow access from a single IP address on the Internet, select Only this PC.

Enter the IP address that will be allowed access. 

3. Specify the Port Number that will be used for accessing the management interface.

Web browser access normally uses the standard HTTP service port 80. For greater security, 
you can change the remote management web interface to a custom port by entering that 
number in the box provided. Choose a number between 1024 and 65535, but do not use the 
number of any common service port. The default is 8080, which is a common alternate for 
HTTP.

4. Click Apply to have your changes take effect.

5. When accessing your firewall from the Internet, the Secure Sockets Layer (SSL) will be 

enabled. You will enter https:// and type your firewall's WAN IP address into your browser, 
followed by a colon (:) and the custom port number. For example, if your WAN IP address is 
134.177.0.123 and you use port number 8080, type the following in your browser:

If you do not use the SSL https://address, but rather use http://address, the FVS318v3 will 
automatically attempt to redirect to https://address.

Note: The first time you remotely connect the FVS318v3 with a browser via SSL, you may get 
a message regarding the SSL certificate. If you are using a Windows computer with Internet 
Explorer 5.5 or higher, simply click Yes to accept the certificate.

Tip: If you are using a dynamic DNS service such as TZO, you can always identify the IP 
address of your FVS318v3 by running 

TRACERT

 from the Windows Start menu Run option. 

For example, type tracert yourFVS318v3.mynetgear.net and you will see the IP address 
your ISP assigned to the FVS318v3.