Netgear FVS318v3 – Cable/DSL ProSafe VPN Firewall with 8-Port Switch 참조 매뉴얼
ProSafe VPN Firewall FVS318v3 Reference Manual
4-16
Basic Virtual Private Networking
v5.0, January 2012
After you have configured and saved the VPN client information, your PC will automatically
open the VPN connection when you attempt to access any IP addresses in the range of the
remote VPN firewall’s LAN.
open the VPN connection when you attempt to access any IP addresses in the range of the
remote VPN firewall’s LAN.
8. Check the VPN Connection.
To check the VPN Connection, you can initiate a request from the remote PC to the
FVS318v3’s network by using the “Connect” option in the NETGEAR ProSafe menu bar. The
NETGEAR ProSafe client will report the results of the attempt to connect. Since the remote
PC has a dynamically assigned WAN IP address, it must initiate the request.
FVS318v3’s network by using the “Connect” option in the NETGEAR ProSafe menu bar. The
NETGEAR ProSafe client will report the results of the attempt to connect. Since the remote
PC has a dynamically assigned WAN IP address, it must initiate the request.
To perform a ping test using our example, start from the remote PC:
a. Establish an Internet connection from the PC.
b. On the Windows taskbar, click the Start button, and then click Run.
c. Type
ping -t 192.168.3.1
, and then click OK.
Figure 4-16
This will cause a continuous ping to be sent to the first FVS318v3. It will take between
several seconds and two minutes for the ping response to change from “timed out” to
“reply.”
several seconds and two minutes for the ping response to change from “timed out” to
“reply.”
Figure 4-17