Netgear WG302v1 - ProSAFE 54 Mbps Wireless Access Point 참조 매뉴얼

2-4

Basic Installation and Configuration

Before installing the ProSafe 802.11g Wireless Access Point , you should make sure that your 
Ethernet network is up and working. You will be connecting the access point to the Ethernet 
network so that computers with 802.11b or 802.11g wireless adapters will be able to communicate 
with computers on the Ethernet network. In order for this to work correctly, verify that you have 
met all of the system requirements, shown in 

1. Prepare a computer with an Ethernet adapter. If this computer is already part of your network, 

record its TCP/IP configuration settings. 

2. Configure the computer with a static IP address of 192.168.0.210 and 255.255.255.0 for the 

Subnet Mask.

3. Connect an Ethernet cable from the WG302 to the computer. 

4. Connect the power adapter to the WG302 and verify the following:

•

The PWR power light goes on. 

•

The LAN light of the wireless access point is lit when connected to a powered on 
computer.

To configure the WG302 Ethernet port for LAN access: 

1. Connect to the WG302 by opening your browser and entering http://192.168.0.228 in the 

address field. A login window like the one shown below will open:

2. When prompted, enter admin

 for the user name and password for the password, both in lower 

case letters. 

Tip: Before mounting the WG302 in a high location, first set up and test the WG302 to 

verify wireless network connectivity.

Note: If there is no activity for 5 minutes, the wireless access point will 

automatically log you out