Netgear WG302v1 - ProSAFE 54 Mbps Wireless Access Point 참조 매뉴얼

iii

Indoors, computers can connect over 802.11 wireless networks at a maximum range of 500 feet (152.4 m) for 802.11b 
devices. However, the operating distance or range of your wireless connection can vary significantly, based on the 
physical placement of the wireless access point.

For best results, identify a location for your wireless access point according to these guidelines:

•

Away from potential sources of interference, such as PCs, large metal surfaces, microwaves, and 2.4 GHz cordless 
phones.

•

In an elevated location such as a high shelf that is near the center of the wireless coverage area for all mobile 
devices.

Failure to follow these guidelines can result in significant performance degradation or inability to wirelessly connect to 
the wireless access point.

To meet FCC and other national safety guidelines for RF exposure, the antennas for this device must be installed to 
ensure a minimum separation distance of 20cm (7.9 in.) from persons. Further, the antennas shall not be colocated with 
other transmitting structures.

We Netgear, 

4500 Great America Parkway

Santa Clara, CA 95054, USA

Tel: +1 408 907 8000

declare under our sole responsibility that the product(s)

WG302 (Model Designation)

ProSafe 802.11g Wireless Access Point  (Product Name)

complies with Part 15 of FCC Rules.  

Operation is subject to the following two conditions:  (1) this device may not cause harmful interference, and (2) this 
device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of 
the FCC Rules.  These limits are designed to provide reasonable protection against harmful interference in a residential 
installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in 
accordance with the instructions, may cause harmful interference to radio communications.  

However, there is no guarantee that interference will not occur in a particular installation.  If this equipment does cause 
harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the 
user is encouraged to try and correct the interference by one or more of the following measures:

•

Reorient or locate the receiving antenna.

•

Increase the separation between the equipment and receiver.