Netgear WG302v1 - ProSAFE 54 Mbps Wireless Access Point 참조 매뉴얼

2-8

Basic Installation and Configuration

4. Connect the power adapter to the wireless access point and plug the power adapter in to a 

power outlet. The PWR, LAN, and Wireless LAN lights should light up. 

Using a computer with an 802.11b or 802.11g wireless adapter with the correct wireless settings 
needed to connect to the WG302 (SSID, WEP/WPA, MAC ACL, etc.), verify connectivity by 
using a browser such as Netscape or Internet Explorer to browse the Internet, or check for file and 
printer access on your network.

The default IP address of your access point is 192.168.0.228. The WG302 is set, by default, with 
the DHCP client disabled. 

1. Open a Web browser such as Internet Explorer or Netscape Navigator. 

2. Connect to the WG302 by entering its default address http://192.168.0.228 into your browser. 

Note: By default, WG302 is set with the DHCP client disabled. If your network uses 

dynamic IP addresses, you must change this setting. To connect to the WG302 
after the DHCP server on your network assigns it a new IP address, enter the 
access point name into your Web browser. The default access point name is 
netgearxxxxxx, where xxxxxx represents the last 6 bytes of the MAC address. 
The default name is printed on the bottom label of the WG302

Note: If you are unable to connect, see 

.”

Note: The computer you are using to connect to the WG302 should be configured 

with an IP address that starts with 192.168.0.x and a Subnet Mask of 
255.255.255.0.