Netgear WFS709TP - ProSafe Smart Wireless Controller 서비스 매뉴얼
Static:
These steps will be followed if the Access Points were previously statically programmed with at least an
LMS IP (Local Master Switch, the wireless controller IP).
LMS IP (Local Master Switch, the wireless controller IP).
1.
AP loads variables from BootROM.
2.
AP sends message to the wireless controller
with it’s location ID. If the
Access point is unable to reach the wireless controller, it will continue to
try to send the same message until it contacts the WFS709TP.
try to send the same message until it contacts the WFS709TP.
3.
If needed, the AP sends TFTP request to the wireless controller and
downloads OS image.
downloads OS image.
4.
Based on the AP’s Location ID, the current switch may take control of
this AP or direct it to another switch.
this AP or direct it to another switch.
5.
If it necessary, the AP authenticates to new switch and establishes GRE
tunnel.
tunnel.
Of notice, by default all WFS709TP compatible APs will have a location code of 0.0.0, which remains until
it is changed by the controller.
NOTE: If there are two APs with the same location code allocated, both of them will boot but only one will
transmit and receive data.