Netgear WFS709TP - ProSafe Smart Wireless Controller 빠른 설정 가이드
Initial Setup Configuring the WFS709TP as a DHCP server
NOTE:
Most existing networks will have already a device offering IP addressing via DHCP, be sure to that
no other device is offering this service before you configure your Wireless Controller as a DHCP server,
as having two DHCP servers in the same network will cause network communication issues.
as having two DHCP servers in the same network will cause network communication issues.
With a computer directly connected to the WFS709TP, change the computer's IP address manually so it
is in the same default IP subnet that the WFS709TP uses – which is 192.168.0.0/24. The default IP
address of the WFS709TP is 192.168.0.250
Open a web browser, and access the initial configuration page via the IP address of the wireless
controller – here you can set up the basic configuration parameters:
is in the same default IP subnet that the WFS709TP uses – which is 192.168.0.0/24. The default IP
address of the WFS709TP is 192.168.0.250
Open a web browser, and access the initial configuration page via the IP address of the wireless
controller – here you can set up the basic configuration parameters:
For this example we’ll use these values, but you can change them to match your current IP scheme. Note
that if you set your controller to a different subnet you will need to change your PC’s IP address to match.
that if you set your controller to a different subnet you will need to change your PC’s IP address to match.