Netgear WN203 - ProSAFE® WIRELESS-N SINGLE BAND ACCESS POINT 사용자 설명서

If the path is not working, you see this message:

Request timed out

If the path is not functioning correctly, you might have one of the following problems:

Wrong physical connections:

Make sure that the

Active LED and LAN LED are lit. If one or both of these LEDs 

are off, follow the instructions in 

Check that the corresponding link LEDs are lit on the hub, switch, or router ports 

that are connected to your computer and the wireless access point.

Wrong network configuration:

Verify that the Ethernet card driver software and TCP/IP software are both 

installed and configured on your computer.

Verify that the IP address for your wireless access point and your workstation are 

correct and that the addresses are on the same subnet.

After verifying that the LAN path works correctly, test the path from your computer to a remote 

device. 

From the Windows toolbar, click the Start button, and select Run.

In the Windows Run window, type:

ping -n 10 <IP address>

where <IP address> is the IP address of a remote device such as the DNS server of your 
ISP.

If the path is functioning correctly, replies as in the previous section display. If you do not 
receive replies:

Check that your computer has the IP address of your router listed as the default wireless 
access point. If the IP configuration of your computer is assigned by DHCP, this 
information is not visible in your computer’s Network Control Panel. Verify that the IP 
address of the router is listed as the default wireless access point.

Check to see that the network address of your computer (the portion of the IP address 
specified by the netmask) is different from the network address of the remote device.

Check that your cable or DSL modem is connected and functioning.

If your ISP assigned a host name to your computer, enter that host name as the account 
name in the basis General system settings screen (see