Netgear WN203 - ProSAFE® WIRELESS-N SINGLE BAND ACCESS POINT 사용자 설명서
Management
56
ProSAFE Single Band 802.11n Wireless Access Point WN203
TFTP Server Upgrade Procedure
To use this method, you need to have a TFTP server set up.
To use a TFTP server to upgrade the wireless access point firmware:
1.
Download the new software file from the NETGEAR website and save it to your hard
disk.
disk.
2.
Place the software file in your TFTP server location. (You do not need to unzip the file.)
3.
If available, read the release notes before upgrading the software.
4.
Select Maintenance > Upgrade > Firmware Upgrade TFTP.
The Firmware Upgrade TFTP screen displays:
5.
Specify the following information:
•
Firmware File Name. The name of the unzipped software file.
•
TFTP Server IP. The IP address of your TFTP server.
6.
Click the Apply button.
The upgrade process is initiated.
During the upgrade process, the wireless access point automatically restarts, and the
Test LED blinks amber. The upgrade process typically takes several minutes. When the
Test LED turns off, wait a few more seconds before doing anything with the wireless
access point.
Test LED blinks amber. The upgrade process typically takes several minutes. When the
Test LED turns off, wait a few more seconds before doing anything with the wireless
access point.
7.
Verify that the new software file has been installed by selecting Monitoring > System.
on page 92). The firmware
version is shown in the Access Point Information section of the screen.