Netgear WAG302v2- ProSAFE Dual Band Wireless Access Point 참조 매뉴얼

2-10

Basic Installation and Configuration

•

Untagged VLAN. You can use VLANS on the WAG302v2 to logically separate traffic 
that is on the same physical network. VLAN tagging is always enabled so that the 
WAG302v2 can process VLAN membership information. 

•

By default all traffic on the WAG302v2 uses VLAN 1, which is the default untagged 
VLAN. Therefore, all traffic is untagged until you change the untagged traffic VLAN ID 
or the VLAN ID for a specific Security Profile. Check the Untagged VLAN check box to 
transmit all frames on the specified VLAN as untagged. If you clear the box, all traffic is 
tagged with a VLAN ID.

•

Time Zone. Select the Time Zone to match your location. If your location uses daylight 
saving, check the box Adjust for Daylight Saving Time. 

•

The Current Time, as used on the wireless access point, is displayed.

•

NTP Server. Click Enable to use a network time protocol (NTP) server to synchronize the 
clock in your access point, or click Disable if you do not want to use an NTP server.

•

Use Custom NTP Server. If you do not want to use the default NETGEAR NTP server, 
click this box and enter the hostname or IP address of the NTP server to use.

3. Click Apply to save your settings.

To configure the wireless settings, connect to the WAG302v2 and click Wireless Settings in the 
Setup section of the WAG302v2 main menu. 

The Wireless Settings menu appears, as shown in 

. The figure shows the 802.11b/g radio 

configuration.

Note: You must have an Internet connection to get the current time.

Note: The configuration options for the 802.11a radio and the 802.11b/g radio are the 

same, but the values are different.The 802.11a and 802.11b/g radios operate on 
different channels and frequencies and have different data rates.