Netgear WAG302v1- ProSAFE Dual Band Wireless Access Point 참조 매뉴얼

iii

•

Away from potential sources of interference, such as PCs, large metal surfaces, microwaves, and 2.4 GHz cordless 
phones.

•

In an elevated location such as a high shelf that is near the center of the wireless coverage area for all mobile 
devices.

Failure to follow these guidelines can result in significant performance degradation or inability to wirelessly connect to 
the wireless access point.

To meet FCC and other national safety guidelines for RF exposure, the antennas for this device must be installed to 
ensure a minimum separation distance of 20cm (7.9 in.) from persons. Further, the antennas shall not be collocated with 
other transmitting structures.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of 
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential 
installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in 
accordance with the instructions, may cause harmful interference to radio communications. However, there is no 
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to 
radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try 
and correct the interference by one or more of the following measures:

•

Reorient or locate the receiving antenna.

•

Increase the separation between the equipment and receiver.

•

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

•

Consult the dealer or an experienced radio/TV technician for help.

We Netgear,

4500 Great America Parkway

Santa Clara, CA 95054, USA

Tel: +1 408 907 8000

declare under our sole responsibility that the product(s)

WAG302 (Model Designation) 

802.11a/g ProSafe™ Dual Band Wireless Access Point (Product Name)

 complies with Part 15 of FCC Rules.

Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this 
device must accept any interference received, including interference that may cause undesired operation

To assure continued compliance, any changes or modifications not expressly approved by the party responsible for 
compliance could void the user's authority to operate this equipment. (Example - use only shielded interface cables 
when connecting to computer or peripheral devices)