Netgear ReadyRECOVER – ReadyDATA-based Backup Appliance 소프트웨어 가이드
Install and Configure ReadyDATA
9
ReadyRECOVER Software
Figure 1. ReadyDATA 5200 with optional disk expansion arrays as displayed on Dashboard
Create a Volume and Select the RAID Level
Note:
ReadyRECOVER requires a dedicated volume. Other workloads,
such as LUNs for virtualization or file server, must be serviced by
separate volumes.
such as LUNs for virtualization or file server, must be serviced by
separate volumes.
For small ReadyRECOVER volumes with six disks or less, RAID 5 or RAID 6 can be used.
Larger ReadyRECOVER volumes with more than six disks should use RAID 50 or RAID 60.
Larger ReadyRECOVER volumes with more than six disks should use RAID 50 or RAID 60.
Table 1. RAID level and required number of disks
RAID Level
Number of Required Disks
Redundancy
RAID 0
1 or more
None
RAID 1
2 only (more disks are not supported in RAID 1) Supported
RAID 5
3 or more
Supported for one disk
RAID 6
4 or more
Supported for two disks
RAID 10
4 or more, but an even number
Supported for all disks