Netgear WAC730- ProSAFE® Business 3 x 3 Dual Band Wireless-AC Access Point 사용자 설명서
Initial Setup
13
ProSAFE Dual-Band Wireless AC Access Points WAC720 and WAC730
Requirements for Entering IP Addresses
IP addresses assigned to the access points must follow the following requirements for IPv4
and IPv6 addresses.
and IPv6 addresses.
IPv4
The fourth octet of an IP address must be between 0 and 255 (both inclusive). This
requirement applies to any IP address that you enter on the access point’s web management
interface.
requirement applies to any IP address that you enter on the access point’s web management
interface.
IPv6
IPv6 addresses are denoted by eight groups of hexadecimal quartets that are separated by
colons. Any four-digit group of zeroes within an IPv6 address can be reduced to a single zero
or altogether omitted.
colons. Any four-digit group of zeroes within an IPv6 address can be reduced to a single zero
or altogether omitted.
The following errors invalidate an IPv6 address:
•
More than eight groups of hexadecimal quartets
•
More than four hexadecimal characters in a quartet
•
More than two colons in a row
Install and Configure the Access Point
Install and configure your access point in the order of the following sections:
Before installing the access point, make sure that your Ethernet network functions. After you
connect the access point to the Ethernet network, computers that support 802.11b/g/a/n/ac
are able to communicate with the Ethernet network.
connect the access point to the Ethernet network, computers that support 802.11b/g/a/n/ac
are able to communicate with the Ethernet network.
For this to work correctly, verify that you meet all the system requirements, shown in