Netgear WAC720- ProSAFE® Business 2 x 2 Dual Band Wireless-AC Access Point 사용자 설명서
Management and Monitoring
57
ProSAFE Dual-Band Wireless AC Access Points WAC720 and WAC730
Your settings are saved.
Manage the Access Point over a Telnet Connection
To manage the access point over a Telnet connection:
1.
Connect an Ethernet cable to the console port of the access point.
2.
Connect the other end of the cable to a VT100/ANSI terminal or a computer.
If you attach a computer that is running a Windows, Apple, or Linux operating system,
start a secure terminal emulation program, and configure the terminal emulation program
to use the following settings:
start a secure terminal emulation program, and configure the terminal emulation program
to use the following settings:
•
Baud rate. 9600 bps
•
Data bits. 8
•
Parity. None
•
Stop bit. 1
•
Flow control. None
3.
Start a secure Telnet session from the terminal or workstation to the access point. A page
similar to the following displays:
similar to the following displays:
4.
Enter the login name and password.
The default login name is admin and the default password is password.
After successful login, the > prompt appears, preceded by the name of the access point.
In this example, the prompt is netgear334408.
5.
Enter the CLI commands that you want to use.
You can enter show configuration to display the available CLI commands.
Note:
You can also access the access point remotely over a Telnet or SSH
session using an application such as PuTTY, if such an encryption
application is allowed by law in your country. After you connect to the
access point, enter the login name and password to access the CLI.
session using an application such as PuTTY, if such an encryption
application is allowed by law in your country. After you connect to the
access point, enter the login name and password to access the CLI.