Netgear RPS4000 – Redundant Power System and Power Bank 하드웨어 매뉴얼
Hardware Installation
13
NETGEAR Managed Switch
WARNING:
Do not remove the RPS cable from the RPS or the powered device
when the connected device is on. First power the device off.
Second, remove the power cord from the power module. Remove
the device RPS power cable.
when the connected device is on. First power the device off.
Second, remove the power cord from the power module. Remove
the device RPS power cable.
RPS4000 Modes of Operation
The RPS4000 rear panel has two slide switches for each of the four RPS ports. Each slide
switch has two positions, left and right. The slide switches control how the RPS4000 provides
power to the client switches.
switch has two positions, left and right. The slide switches control how the RPS4000 provides
power to the client switches.
RPS configuration switches
Type switch: In the Old (right position), the RPS is set to back up redundant power to a switch
of pre-RPS4000 design.
of pre-RPS4000 design.