Netgear APS135W – ProSAFE 135W Auxillary Power Supply 설치 가이드

)NSTALLATION

July 2009

e

The ProSafe Auxiliary Power Supply APS135W provides a replaceable power supply for the 
GSM73xxSv2 series gigabit switches. You can make use of an RPS (Redundant Power 
Supply) while replacing the power supply. Refer to the switch Hardware Installation Guide 
for additional information. When an RPS is used, the power supply can be replaced without 
stopping the switch or requiring a reboot.

Note: The power module has a “hot swap” capability. It is not necessary to remove the AC 
power cord from the power supply module when removing the power supply module.

To remove the APS135W power module, follow these steps:

1.  Loosen the two captive screws on the power module.

2.  Remove the power module from the power module slot by pulling on the extraction 

handle.

RPS C

onnec

tor

To install an APS135W power module, follow these steps:

Warning: When inserting a power module into the switches, do not use unnecessary force. 

Doing so can damage the connectors on the rear of the supply and on the midplane.

1.  Insert the new power supply module into the power module slot, and gently push the 

module into the slot. 

2.  Align the two captive screws with the screw holes in the switch’s back panel. 

3.  Using a screwdriver, gently tighten the captive screws.

4.  If not connected, insert the AC power cord into the power module and connect the 

power cord to an AC outlet. 

Dimensions (HxWxD)

8.40” x 7.64” x 1.66”
(216mm x 194mm x 42.4 mm)

Weight

2.87 lb (1.3kg)

Operating Temperature

32 to 122 ºF (0 to 50 ºC)

Storage Temperature

-49 to 185 ºF (-45 to 85 ºC)

Operative relative humidity

10 to 90% and non condensing

MTBF

2,237,887 Hours (~255 years) @ 25 ºC