Netgear GS510TP – ProSAFE 8-Port Gigabit Smart Switch with PoE and 2 fiber SFP ports 관리자 가이드
Managing Device Security
169
GS510TP and GS110T Gigabit Smart Switches
To configure MAC ACL interface bindings:
1.
Select an existing MAC ACL from the ACL ID menu.
The packet filtering direction for ACL is Inbound, which means the MAC ACL rules are
applied to traffic entering the port.
applied to traffic entering the port.
2.
Specify an optional sequence number to indicate the order of this access list relative to other
access lists already assigned to this interface and direction.
A low number indicates high precedence order. If a sequence number is already in use
for this interface and direction, the specified access list replaces the currently attached
access list using that sequence number. If the sequence number is not specified by the
user, a sequence number that is one greater than the highest sequence number currently
in use for this interface and direction will be used. The valid range is 1–4294967295.
for this interface and direction, the specified access list replaces the currently attached
access list using that sequence number. If the sequence number is not specified by the
user, a sequence number that is one greater than the highest sequence number currently
in use for this interface and direction will be used. The valid range is 1–4294967295.
3.
Click the appropriate orange bar to expose the available ports or LAGs.
•
To add the selected ACL to a port or LAG, click the box directly below the port or LAG
number so that an X appears in the box.
•
To remove the selected ACL from a port or LAG, click the box directly below the port
or LAG number to clear the selection. An X in the box indicates that the ACL is
applied to the interface.\
applied to the interface.\
In the following figure, the MAC ACL named mac2 is being applied to ports g3, g6, and
g7. As the Interface Binding Status table indicates, these ports also have a MAC ACL
named mac1 applied in the inbound direction.
g7. As the Interface Binding Status table indicates, these ports also have a MAC ACL
named mac1 applied in the inbound direction.
4.
Click Cancel to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
5.
Click Apply to save any changes to the running configuration.
MAC Binding Table
Use the MAC Binding Table page to view or delete the MAC ACL bindings.
To display the MAC Binding Table, click Security > ACL, then click the Basic > Binding
Table link.
Table link.