Netgear GS510TP – ProSAFE 8-Port Gigabit Smart Switch with PoE and 2 fiber SFP ports 관리자 가이드
Configuring System Information
46
GS510TP and GS110T Gigabit Smart Switches
•
LLDP-MED+User.Select this option if the power limit should be determined based
on the power specified in the LLDP MED packet. This option also allows the
power limit type to switch to User mode if the power in the LLDP MED packet is
more than the amount of power the port can deliver.
power limit type to switch to User mode if the power in the LLDP MED packet is
more than the amount of power the port can deliver.
•
Class: Select this option to base the power limit on the detected class value.
When this value is selected, the user-configured value configured in the Power
Limit field is ignored.
Limit field is ignored.
•
User: Select this option to base the power limit on the value configured in the
Power Limit field.
•
Power Limit. Set the maximum amount of power that can be delivered by a port when
the Power Limit Type is User.
•
Status. View the operational status of the port PD detection.
•
Disabled. Indicates no power is being delivered.
•
DeliveringPower. Indicates power is being drawn by a connected device.
•
Fault. Indicates a problem with the port.
•
Test. Indicates the port is in test mode.
•
OtherFault. Indicates the port is idle due to an error condition.
•
Searching. Indicates the port is not in one of the above states.
•
Requesting Power. Indicates that a valid PD has been detected, but the device is
not able to deliver power to the PD due to a power management decision.
4.
Click Apply to apply the new settings to the system.
5.
Click Cancel to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
6.
Click Refresh to update the screen with the current information.
Timer Global Configuration
Use the Timer Global Configuration page to create or remove timers and to control the
administrative status of the feature. Timers control when power can and cannot be delivered
to the port. Use the following general steps to add a timer to a port:
administrative status of the feature. Timers control when power can and cannot be delivered
to the port. Use the following general steps to add a timer to a port:
1.
Create the timer on the Timer Global Configuration page.
2.
Configure the timer settings on the Timer Schedule Configuration page.
3.
Assign the timer to the port on the PoE Port Configuration page.
Note:
The Timer Schedule feature must be enabled for the settings to be
applied to the ports. Additionally, for the Timer to work, the clock
source must be SNTP. For information about the clock source,
see
source must be SNTP. For information about the clock source,
see