Netgear PS121v2 - USB Mini Print Server 설치 가이드

This symbol was placed in accordance with the European Union Directive 
2002/96 on the Waste Electrical and Electronic Equipment (the WEEE 
Directive). If disposed of within the European Union, this product should be 
treated and recycled in accordance with the laws of your jurisdiction 
implementing the WEEE Directive.

© 2007 by NETGEAR, Inc. All rights reserved. NETGEAR is a registered trademark of NETGEAR, Inc. in the 
United States and/or other countries. Other brand and product names are trademarks or registered trademarks of 
their respective holders. Information is subject to change without notice. 

Here are some tips for correcting simple problems you may have.

It takes a few seconds for the status light to be lit. Check the power connection to the 
USB print server. Wait a minute and check the status light on the print server.

If the printer does not match the printer driver in the operating system, then run the 
Windows Add Printer Wizard. 

Consult Windows help. 

See if you can access it from other computers on your network. If so, troubleshoot 
your computer or network connectivity.

If you are running a software firewall, disable it. This includes the Windows XP 
firewall — which may have been turned on during Windows upgrade or installation 
without you being aware of it.

–

Try printing from another computer. If this is successful, then there is a problem 
with your computer configuration, not the print server. Consult the computer and 
operating system documentation.

–

If the printer does not match the printer driver in the operating system, then run 
the Windows Add Printer Wizard. 

–

For Windows 98 SE and Windows ME users, disable the printer's bidirectional 
feature, if it is turned on.

–

For Windows 2000 and Windows XP users, enable the printer bidirectional 
feature if it is not turned on.

–

If printer manager software is installed on Windows 98SE or ME, uninstall it.

–

See Troubleshooting in the User Manual on the Resource CD.

This can happen if the PS121v2 is set to a static IP Address in the range used by the 
DHCP server. Make sure that you reserve the PS121v2 IP address in your router. If 
you are using a NETGEAR router, see the Reference Manual on the Resource CD.

Thank you for selecting NETGEAR products. 

After completing the Smart Wizard configuration assistant, locate the serial number on the 
bottom label of your product and use it to register your product at 
http://www.NETGEAR.com/register. 

Registration on the website or over the phone is required before you can use our telephone 
support service. The phone numbers for worldwide regional customer support centers are 
on the Warranty and Support Information card that came with your product. 

Go to http://kbserver.netgear.com

 for product updates and web support.