Netgear M4200-10MG-PoE+ (GSM4210P) - Multigigabit Managed Switch with 8*2.5G and 2x10G SFP+ Layer 3 관리자 가이드

A screen similar to the following displays.

b.  Select the 2/0/21 check box to the left of the Interface column.

2/0/21 displays in the Interface field of the table heading.

c.  In the Admin mode field, select Enable.

d.  In the Pool Name field, select ipv6_server.

e.  Click Apply to save the settings.

This example shows how you can use a DHCPv6 server to assign an IPv6 address directly to 
a client in the same way that an IPv4 DHCPv4 server assigns an IPv4 address to an IPv4 
client. A stateful DHCPv6 server assigns the IPv6 address to a client based on the configured 
IPv6 prefix in the DHCPv6 pool.

The following sections show how to configure a DHCPv6 server that functions in stateful 
mode.

Enable IPv6 routing.

Create an IPv6 pool with a DNS server and enable the DHCPv6 service.

(Netgear Switch) (Config)#ipv6 unicast-routing

(Netgear Switch) (Config)#ipv6 dhcp pool ipv6_server 

(Netgear Switch) (Config-dhcp6s-pool)#address prefix 2001:1:2::/64

(Netgear Switch) (Config-dhcp6s-pool)#exit

(Netgear Switch) (Config)#service dhcpv6