Netgear M4200-10MG-PoE+ (GSM4210P) - Multigigabit Managed Switch with 8*2.5G and 2x10G SFP+ Layer 3 소프트웨어 가이드
IP Multicast Commands
1015
M4200 and M4300 Series ProSAFE Managed Switches
Internet Group Message Protocol Commands
This section describes the commands you use to view and configure Internet Group
Message Protocol (IGMP) settings.
Message Protocol (IGMP) settings.
ip igmp
This command sets the administrative mode of IGMP in the system to active on an interface,
range of interfaces, or on all interfaces.
range of interfaces, or on all interfaces.
no ip igmp
This command sets the administrative mode of IGMP in the system to inactive.
ip igmp header-validation
Use this command to enable header validation for IGMP messages.
no ip igmp header-validation
This command disables header validation for IGMP messages.
Default
disabled
Format
ip igmp
Modes
Global Config
Interface Config
Format
no ip igmp
Modes
Global Config
Interface Config
Default
disabled
Format
ip igmp header-validation
Mode
Global Config
Format
no ip igmp header-validation
Mode
Global Config