Netgear M4200-10MG-PoE+ (GSM4210P) - Multigigabit Managed Switch with 8*2.5G and 2x10G SFP+ Layer 3 소프트웨어 가이드
Management Commands
56
M4200 and M4300 Series ProSAFE Managed Switches
no ip cpu-priority
This command removes all packets with a specified destination IPv4 address from the higher
priority queue.
priority queue.
ipv6 cpu-priority
The command allows all packets with a specified destination IPv6 address into a higher
priority queue (5) than the default queue for data packets and unicast packets to the CPU.
priority queue (5) than the default queue for data packets and unicast packets to the CPU.
no ipv6 cpu-priority
This command removes all packets with a specified destination IPv6 address from the higher
priority queue.
priority queue.
Management Interface Commands
This section describes the commands you use to configure a logical IPv4 interface for
management access.
management access.
enable (Privileged EXEC access)
This command gives you access to the Privileged EXEC mode. From the Privileged EXEC
mode, you can configure the network interface.
mode, you can configure the network interface.
Format
no ip cpu-priority ip-address
Mode
Privileged EXEC
Format
ip cpu-priority ipv6-address
Mode
Privileged EXEC
Format
no ip cpu-priority ipv6-address
Mode
Privileged EXEC
Format
enable
Mode
User EXEC