Netgear FS728TPv2 - ProSAFE 24 Port 10/100 Smart Switch with 4 Gigabit Ports and 24 PoE Ports 관리자 가이드
118
|
Chapter 3: Configuring Switching Information
FS728TP Smart Switch Software Administration Manual
To configure the Dynamic Address setting:
1.
Specify the number of seconds the forwarding database should wait before deleting a
learned entry that has not been updated. IEEE 802.1D-1990 recommends a default of
300 seconds. You may enter any number of seconds between 10 and 1000000. The
factory default is 300.
Note:
IEEE 802.1D recommends a default of 300 seconds, which is the
factory default.
2.
Click Cancel to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
3.
Click Apply to apply to send the updated configuration to the switch. Configuration changes
take effect immediately.
Static MAC Address
Use the Static MAC Address Configuration page to configure and view static MAC addresses
on an interface.
on an interface.
To access the Static MAC Address Configuration page, click Switching
Address Table
Advanced
Static MAC Address.