Netgear M4200-10MG-PoE+ (GSM4210P) - Multigigabit Managed Switch with 8*2.5G and 2x10G SFP+ Layer 3 하드웨어 매뉴얼
Introduction
6
Managed Switch Series M4200
•
AutoSensing and autonegotiating capabilities for all ports.
•
Auto Uplink technology is supported on all ports.
•
Automatic address learning function to build the packet-forwarding information table. The
table contains up to 16K Media Access Control (MAC) addresses.
•
Store-and-forward transmission to remove bad packets from the network.
•
Full-duplex IEEE 802.3x pause frame flow control.
•
Active flow control to minimize packet loss and frame drops.
•
Half-duplex backpressure control.
•
Per-port status LEDs and system status LEDs.
•
NETGEAR green power-saving features:
-
Energy efficiency mode that fully conforms to the IEEE802.3az standard
-
For 1GBASE-T ports, per-port automatic change to a lower power mode when the
port link is down
port link is down
•
Support for Power over Ethernet (PoE+).
Safety Instructions and Warnings
Use the following safety guidelines to ensure your own personal safety and to help protect
your system from potential damage.
your system from potential damage.
To reduce the risk of bodily injury, electrical shock, fire, and damage to the equipment,
observe the following precautions:
observe the following precautions:
•
This product is designed for indoor use only in a temperature-controlled (0–50
º
C) and
humidity-controlled (10–90 percent relative humidity) environment.
Any device that is located outdoors and connected to this product must be properly
grounded and surge protected.
To the extend permissible by applicable law, failure to follow these guidelines could result
in damage to your NETGEAR product, which may not be covered by NETGEAR’s
warranty.
in damage to your NETGEAR product, which may not be covered by NETGEAR’s
warranty.
•
Observe and follow service markings:
-
Do not service any product except as explained in your system documentation.
-
Opening or removing covers that are marked with the triangular symbol with a
lightning bolt can expose you to electrical shock. We recommend that only a trained
technician services components inside these compartments.
lightning bolt can expose you to electrical shock. We recommend that only a trained
technician services components inside these compartments.
•
If any of the following conditions occur, unplug the product from the electrical outlet and
replace the part or contact your trained service provider:
replace the part or contact your trained service provider:
-
The power cable, extension cable, or plug is damaged.
-
An object fell into the product.
-
The product was exposed to water.